Doors
Sliding
LARGE-SCALE SLIDING DOORS
SLIDING DOORS designed for large openings
Sliding doors on tracks is ideal for closing large spaces, especially aircraft hangars and shipyards.
The door opens thanks to sliding the panels, top-guided and supported by continuous or stepped parallel floor rails.
Maximum safety without sacrificing aesthetics.
SLIDING doors on
CONTINUOUS or STEPPED tracks
Stepped parallel tracks are used when space is available outside the building’s clear opening for the panels to be stacked in a fixed position when opened.
Continuous parallel tracks, on the other hand, are used when no external stacking space is available. In this case, the panels are stacked in any position when opened, occupying part of the building’s clear opening (according to their width).
The door can be built with manual or motorised operation, with independent panels.
SLIDING doors:
our solutions
WITH CONTINUOUS parallel TRACKS
- Clear opening: No width limitations (multiple of the width of the panels) / max height of approximately 35m
- Opening: Independent sliding of each panel, guided at the top and resting on wheels on the floor
- Stacking arrangement: Single or double section, internal / external
- Parallel tracks: Continuous/stepped
- Parallel top guides: Continuous/stepped
- Panels: Number, dimensions, and architectural style of request
- Execution: Motorisaton of each individual panel with electromechanical system
- Speed: Opening/closure 10m/minute
- Control panel: Electromechanical with electronic logic
- Control devices: Buttons on the side of the panels
- Operating cycle: Hold-to-run buttons (operator present)
- Safety devices: Electromechanical double safety edge on each panel
- Signalling device: Flashing light and audible alarm.
WITH STEPPED parallel TRACKS
- Clear opening:No width restrictions (multiple of the width of the panels) / max height approximately 35m
- Opening: Independent sliding of each panel, guided at the top and resting on wheels on the floor
- Stacking arrangement: Single or double section, internal / external
- Parallel tracks: Continuous/stepped
- Parallel top guides: Continuous/stepped
- Panels: Number, dimensions, and architectural style of request
- Execution: Motorisaton of each individual panel with electromechanical system
- Speed: Opening/closure 10m/minute
- Control panel: Electromechanical with electronic logic
- Control devices: Buttons on the side of the panels
- Operating cycle: Hold-to-run buttons (operator present)
- Safety devices: Electromechanical double safety edge on each panel
- Signalling device: Flashing light and audible alarm.
WITH STEPPED parallel TRACKS AND DRIVE SYSTEM
Drive system
A motor or manual device connects the panels and enables their movement. This system can be operated by a chain drive, toothed-belt drive or direct drive link to the motorisation.
CERTIFICATIONS
Certifications and compliance for LARGE-SCALE doors
Directive 2014/35/EU
On the harmonisation of the laws of the Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits.
Directive 2014/30/EU
On the harmonisation of the laws of the Member States relating to electromagnetic compatibility.
UNI EN ISO 12100:2010
Safety of machinery – General design principles – Risk assessment and risk reduction.
UNI EN ISO 13857:2020
Safety of machinery – Safety distances to prevent hazard zones being reached by upper and lower limbs.
UNI EN ISO 13854:2020
Safety of machinery – Minimum gaps to avoid crushing of parts of the human body.
CEI EN 60204-1:2018
Safety of machinery – Electrical equipment of machines. Part 1: General requirements.
UNI EN 12453:2017
Industrial, commercial and garage doors and gates – Safety in use of power operated doors – Requirements and test methods.
UNI EN 12604:2021
Industrial, commercial and garage doors and gates – Mechanical aspects – Requirements and test methods.
UNI EN 12635:2009
Industrial, commercial and garage doors and gates – Installation and use.
